Instructions

• !!! Click on the label to delete all connections for the corresponding node.
• Make connections by dragging nodes from aparatus to the circuit.
• Connect power-supply to the right most nodes of the curcit. (1->9, 2->10)
• Connect ammeters (3-11, 4-12) and (5-13, 6-14) and (7-15, 8-16) or you can connect any ammeter to any resistance in circuit.
• Click on the label to delete all the connections for the corresponding nodes.
• Check your connections by clicking on the 'CHECK' button.
• Set the values of resistances R1, R2, R3 by adjusting the sliders on left, these values will remain constant throughout the experiment.
• Turn on the Power Supply and choose a voltage value, the reading on ammeters will change accordingly.
• Click on the 'ADD' button to add the values to observation table.
• Add a few observations to the table by while changing the value of voltage from Power Supply.
• Click on the 'PLOT' button to create a plot.
• Click on 'RESET' button to refresh the page.